Completely restored Datsun 240z steering that has been professionally painted with interior horn hardware that is cadmium plated. This is the correct steering wheel for your early Datsun 240z up...
S U carburetor center linkage for late 1971 and 1972 240z.
Water pump pulley that has been restored to factory. Will fit all years of the 510 models NOT PLATED AT THIS TIME BUT AVAILABLE
Non emissions Air cleaner housing that has been restored to factory condition. A part that very Hard to find.
Pictured is a complete New set of brake and fuel line retainer brackets. Comes with brand new bolt on hardware to install. .
Brand from Nissan is a engine head pipe that installs on the back side on the passenger side on either the E31 or E88 head.
Brand new engine slingers for installing or removing of your engine in your Datsun 240z car.
Datsun 240z intake installation hardware kit to bolt on to your intake and exhaust manifolds to your engine. It also includes the hardware to install your fuel rail. Willalso work...
Completely restored intake manifold with with brand new gaskets, and bolts. All hardware has been cadmium plated. The aluminum housing has high temperature clear coated that provides better performance from...
Brand new intake water linkage kit that installs between the front and rear intake manifolds.
Brand New coil with bracket that will fit the Datsun 240z from 1970 to 1973 .
Brand oil pan bolts from Nissan. 31 bolts are needed for install.
Brand new Nissan bolts to connect your lower joint steering assembly To your rack and pinion under the engine. Sold in pairs of 2 to complete the rebuilt.
A set of thermostat bolts to install it to the engine next to the intake manifold. Sold in sets of 4
L-Series new water pump with gasket.
Brand new from Nissan is a 5 speed transmission pinion with new seals for proper installation. This transmission speedo pinion will work for 5 speed from 1977 to 1983.
Brand new electronic distributor from Nissan for your Datsun 280z.
Brand new speedo cable from Nissan. Will fit all 510 cars from 1969 to 1973
Brand new from Nissan, plastic retainers for your door opening linkage rods. Suitable for all Datsun models manufactured from 1968 to 1980. Sold in sets of 2
Brand new from Japan from the supplier that provide the transmissions to Nissan. Will rebuilt all transmissions from 1970 to 1983 in Datsun 240z, 260z 280z cars Will also...
Complete remanufactored 60 watt alternator to up grade your electrical system in your 240z car. Will make your engine and light systems better with no dimming of your lights or...
Brand new bolt on hardware from Nissan to install your engine in your z car. Kit includes mounting hardware to engine block and rubber mounts. Kit is 8 bolts,4 nuts...
Brand new clutch fan nuts to install your fan clutch fan on to the front of your engine. Sold in set of 4
Brand new from Nissan is a drain plug for either your oil pan or gas tank on your car .Also comes with new retainer washer . 2 are needed for...
A brand New Z oil pressure wire holder that installs on the passenger side engine mount that keeps the wire harness from disconnecting from the oil indicator at the bottom...
Brand New stainless steel brake line that are manufactured in the USA that will improve your braking response in your z car from 1970 to 1978. Limited amount is...
Brand new turbo oil pump with new gasket. This pump will make your engine run cooler. Will work for all engines from 1970 to 1983 in z cars